Treasure Cove TC-3020 Manuel du propriétaire télécharger pdf (Page 12)

Sweep slowly hurrying will cause you to miss targets.

 It’s better you sweep the search coil from side to side in an arc line

of 3 inches motion and keep the search coil parallel with the ground.

If the detector detects the item, it sounds a tone, an arrow and the

depth appear on the display below the target icon.

If the detector does not detect the item, make sure that the target mode

is set correctly for the type of metal you’re searching for. Also make

sure that you’re moving the search coil correctly.

Notes:

The detector responds with a signal when it detects most valuable

metal objects. If a signal does not repeat after you sweep the

search coil over the target a few times, the target is probably junk

metal.

False signals can be caused by trashy ground, electrical

interference, or large irregular piece of junk metal.

False signals are usually broken or non-repeatable.

Adjusting SENSITIVITY

After you become familiar with how your detector works, it’s important to

fine tune the sensitivity to get a good effect.

Press the touch button SENS on the panel. Then press UP or Dn to

increase or decrease the sensitivity. The level on the segment will

be displayed from high to low position.

Note:

In order to detect the target deeply buried, you can adjust the SENS

1 2 ... 7 8 9 10 11 12 13 14 15

Pas de commentaire

Treasure Cove TC-3020 Manuel du propriétaire Page 12