Treasure Cove TC-3020 Manuel du propriétaire télécharger pdf (Page 9)

OPERATION

TURNING ON THE DETECTOR

1. Slide the power switch to ON. The unit displays all symbols on the

LCD screen. The detector sounds low , medium, high tones

respectively. After about 2 seconds the detector enters stand-by state.

At this time the LCD displays ALL METAL and SENS. The value of

SENS on the segment is 5. The range from MIN. to MAX. for

DISC/NOTCH is available.

2. SETTING THE OPERATION MODE

The detector comes with three operating modes of ALL METAL, DISC,

NOTCH. You can select the desired mode by relative touch key.

a. ALL METAL—used for detecting any type of metal. When the

detector detects any type of metal, it sounds a tone.

Note: When you operate in this mode, controls of DISC and NOTCH do

not function except SENS. To adjust the sensitivity, first press SENS

and UP to increase the sensitivity, then press Dn to decrease it.

b. DISC—used for target discrimination. You can set the target range

from MAX to MIN by pressing DISC/NOTCH and UP & Dn keys. The

detector can detect the metal type indicated on the display.

Meanwhile the detector rejects other metal types without displaying

on the screen. For example, press Dn key, 4 levels on segment from

Max to Min is increased. At this time, the detector can detect S- CAPS,

1¢ and also 25¢, other types of metal are rejected.

c. NOTCH—to ignore the metal type you do not want. You can select

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Treasure Cove TC-3020 Manuel du propriétaire Page 9